Sunnen AN-1060 Heavy Duty Hone Driver w/ Milwaukee Drill Motor & Manual

Description

Up for sale is a used Sunnen AN-1060 Heavy Duty Hone Driver which incorporates a Milwaukee Drill Motor
Sunnen Portable Hones may be driven by a wide variety of power units such as air drills, electric drills, hydraulic motors, radial drills, drill presses, etc.  The heavy duty, slow speed electric drill is one of the more popular methods of driving these hones. The AN-1060 Drill Motor Kit is available from Sunnen for honing bores larger than five inches.
This drill motor kit is geared for the lower speeds and, as a result, has high torque. As a safety precaution, some method should be provided to take the honing torque off the operator.  The AN-1055/1060 Drill Motor is suggested for use with the AN-815 Portable Hone in the diameter range of five inches and larger. It may also be used with the AN-815 and other Sunnen Portable Hones for bores smaller than 127 mm (5").
The AN-1060 Drill Motor has a speed torque relationship that is not found in ordinary electric drills. The power unit operates at 115V, has a no-load speed of 250 rpm and a full-load speed
of 165 rpm. Has a full-load amp draw of 11 amps. Supplied with quick coupler end as pictured.
This is part of a large lot of Sunnen hones, accessories, stones and equipment that were liquidated by a large Seattle university.  Most were unused and can be seen in my other listings so please have a look.  Check back from time to time as I will not be done posting it all till Labor Day.  Cheers